Saddlebag Housing Tail Light For 2014-2017(Black Housing Smoke Light)

I love the look. Likes great with my other lights. Only thing doesn’t seem to work as brake lights. Only as running lights and turn signals. Anyone know how I might install to and use as brake lights comments welcome.

Ottimo

These are VERY BRIGHT - which is a good thing!!! I don't like that the Rushmore bikes only have two small tail lights and no dedicated stop light. It may have been cool to be unsafe thirty years ago, but not anymore. I've always been concerned about being rear-ended. My wife's previous husband lost his life when someone rear-ended him (of course, him not wearing a helmet was a big factor in that). These will definitely get people's attention. These appear to be exact copies of the one's available from H-D - at much less the cost. They are definitely high quality and even use genuine 3M double-sided tape to attach to the bags. For all I know, they're made at the same factory in China as the H-D ones. The ONLY negative thing I have to say is that they come on when the ignition switch is on ACC (regular tail lights are off). Not a big deal as I can always unplug them in the bags. IDK if the real H-D ones do the same or not but considering the price difference, I don't care. NOTE: These DO NOT come with installation instructions. We are MEN (mostly) and we don't read them anyway!!! If you really need instructions, download them from the H-D website or consider trading in your Harley for a Goldwing. For the benefit of your wife who may buy these for you... Installation was easy. I did it in 15 minutes with a Phillips screwdriver and wire cutters to trim the ends off the zip-ties (not included, BTW). They plug into a connector under the seat. Unplug the existing connector and plug the control box into the two ends of the connector you just unplugged - then run the long ones out to the bags. Before you zip-tie them in place, check your turn signals to make sure you have the right & left sides correct. I ran the wires out to just behind the shocks and then up and over into the bags (with the connector for each light inside the bags). Make sure your bags are clean (use rubbing alcohol) before sticking the lights on. Peel a small part of the red stuff off the double-sided tape first. Hold them in place and peel the rest from underneath (while still holding in place). Press firmly to make sure it's stuck tight.

Added to the look of my Harley until three out of six of the right side quit working. Now I've bought these same for other bikes and never had a problem. I'm hoping someone from Amazon or the manufacturer reads this and can send me a new one. Again right side only as they were just purchased November of 21.

They work perfectly, they look exactly like the original Harley and cheaper in price. Totally happy with them.