Gikfun 10mm LED Emitting Diodes Light Lamp Diffused F10 Round Led for Arduino (Pack of 20pcs) AE1258U

I used these leds for a warning system for a burner, they were perfect for the job and were delivered very fast, thankyou

Variety

Reasonably bright but the component legs are thin and few broke off close to the LED body. The actual bend was made 5mm further down the leg.

We used some of these for a toy traffic light project. Note that the dropping voltage is about 2 volts for the yellow and red and 2.9 volts for green. They make sufficient light at about 15 mA, and top out above 20 mA. The yellow seems to make less light than red, green, and blue, but that was okay for our project. These are not ultra bright, but are sufficient for indicators. Sizes seem consistent, but the flanges aren't very large, so you need to get your holes properly drilled at exactly 10mm diameter.

Très bien

I know about the % difference between, LEDs it is usually a change of maybe .10 give or take a little...BUT not ~.50mm and I know this because i deal with 10mm all the time, the issue is that .10 is a standard, .50 is NOT. Pair this with grossly over sized 10mm beveled holders, that are 10.33 you now are sitting at .80 Almost 1mm around the whole thing so .50mm on each side, of the Holder with this LED, and it doesnt even hold at all.... I never seen this type of grossly undersized LEDs in my life, these in other words are unuseable for the project I am working on. They need to get QC involved really, .50mm or .25 each side is a major thing when using them in a holder.Other than the groosly undersized of the LED, they work, they are bright...so I give them that...just cannot use them or even return them now. Waste of money.