2PCS Impact Bit Holders 1/2 Inch Square Drive to 1/4 Inch Hex Socket Adapter for Impact Wrench

good adapter

Convenient to use with impact driver. No need to get a drill motor.

Just be careful if you use an impact wrench you could broke the bits if you put to much pressure

Impact hammer I have is 1/2 drive, and I’ve been using step downs and a socket before I came across this. Will definitely be putting this socket through its paces.

I had previously wrote a review about how the bits were bent and wobbled around. Unfortunately, I thought that I was past the return date and would not be able to get a refund so I threw them away. The seller contacted me and offered a 50% refund or a replacement. I opted for the replacement and today I got a new set of bits. The new ones were not bent and worked great! Thank you for the replacement.

The little check ball that holds the bit in failed and fell out after only a few uses, so the bit falls out.

Edit: Company followed up and took care of this ordeal!Aren't reliable. The metal band which holds the small ball in, jumps out of place. Adapter then doesn't hold the bit. One of the adapters cracked

When installing bits they fit into the adapter easily they hold well and you can pull them out with your fingers even if oily, the 3/8 side fits well on your tool also. Hard to express how NOT frustrating they are

No me gustó que se mueve excéntrico al girar

They look good... but poor design.. Any 1/4 drive bits you fit into these holder will sort of click firmly into the bit for the first couple of times and then after that they remain a sloppy fit and just fall out.