4PCS Parking Assist Sensor Bezels

They did not fit, it’s my fault because I did not ordered the right ones . Just make sure that you order the right ones for your type of vehicle’s.

Only needed 1 when changing my bumper out. Went right in no problems and held my sensor good.

Worked okay but not the strongest plastic

Buen producto

Zero stars. This product is a piece of junk! I've never written a review in my life. What a waste of time and money. The plastic is super soft and cheap. Will not hold the sensor in the bumper. The existing one that snapped did so because it was a hard, firm plastic that locked the sensor into place. This replacement is a soft sponge. DON'T BUY THIS PRODUCT!!!!

Did the job

Ordered from measurements in product description to replace OEM retainers which were only sold with the sensor for $750 each. Saved about $1500 to replace 2 small pieces of plastic.

They fit kind of loose

They aren’t a snug fit. You can wiggle them around. Ended up cleaning the old ones and putting them back in.

Had to try a few from the pack before I found one that seemed to "snap" into place better than the others, thankfully only needed 1. Can definitely tell which one on my bumper is the replacement cause it doesn't seem to sit flush like the oem. That being said my park sensors work as they're supposed to and for the price it's doing as advertised.

Very sloppy fit , i bought bezel and sensors from AUTOHAUX hoping to have trouble free installation ..... WRONG !! :-( the bezel was a loose fit in bumper , hoping sensor would TIGHTEN up the fit ..... not the case .... ended up using silicone so bezel/sensors ass'y would not fall out of their hole :-( :-(

Agreed with another reviewer. The plastic itself is very soft and dont hold the sensor in them. Can fold sensor tabs to 45 degrees and it wont break so some bumps the holder flexes and sensors drop out.