Test Lead Kelvin Clip to 4-channel Banana Plug (3 feet)

Bought these for doing 4-wire Ohms with multiple Fluke 884X-series DMMs. All four of the banana plugs were very difficult to insert into the jacks on all of the meters. From the scuff marks on the shrouds it appears the outside diameter of the middle third of the shrouds is slightly too large and causes binding. Cutting back the shrouds to half their original length eliminated enough of the binding to make the leads usable. Other than this mechanical issue, they work fine and are well worth the money. Note: there was no binding when these were used with Fluke 115/117 DMMs. YMMV with other equipment.

Little pricey, but these Kelvin clips are VERY well made. I have an older set of Kelvin clips from someone else that are not nearly as good.

Not only do they work well, the build quality is pretty nice. They kind of looked crappy to me in the photos but they're nice to work with. Good clamping force, yet very thin tip allowing you to connect to smaller things than you'd expect.What a bargain! That's a bargain for me. I think I will buy some.

Quickly received and worked well. seem to be of reasonable quality. Would buy again

Really nice, both the cables and clips. The problem I had with these while modding them for the DE-5000 is that there are no shields! I couldn't get them to pass the open calibration. After doing some research I found that shields are not needed. I decided to cut a foot off of all 4 cables from the meter end and resolder them to the DE-5000. This worked like a charm, calibrates with no problems now. These are extremely flexible cables and I put heat shrink every 6 inches on the red cables and the black cable, then used bigger heat shrink on all 4 wires. It really makes them less messy. These leads turn a great meter like the DE-5000 into an awesome meter!!

I needed some Kelvin leads for a milliohm meter and these are great quality. The ends are sturdy and the cables are very flexible. These things are great!

Recieved and.the leads on the black alligator clip won't plug into meter. There appears to be quality control issue with the leads and I'm unable to use the black alligator at all. It looks like banana jack is defective. This is ashame because I really hoping to use these and can't. I have other AST leads and they are quality. Can't recommend this product because mine arrived defective.

These probes are great. I have been using them with my Fluke 8842A. I did have to use a knife to shave a little bit of the plastic off the outer surface of the probe plugs. They are too thick to fit into most CATIII sockets. I won't deduct any stars for this. The probes work really well and are small enough at the tip that they are useful for almost any general purpose probing, aside from using them for measuring at IC pins (especially SOIC or TSSOP).It is clear that these function well as kelvin probes. I can measure 0.1 and 0.01ohm resistors with these and am relatively confident in the result. The values don't jump around like they do with 2-lead probes.