REEKON M1 Caliber Adapter Fence – Allows M1 Caliber Mounting on Wide Variety of Miter Saws and Chop Saws, Aluminium Mounting Point, 4 Fasteners Included for Easy Installation

Materials were very sturdy. There were no instructions but install was self explanatory. I recently bought the M1 and the quality is top notch

This is not a bad product IF you need it. I was using mine on the Milwaukee M18 12 inch model. I removed it because the fence on that model is taller than this adapter. If they made one that was taller, I would use it because the ease of taking it on and off with the metal band at the top is just quicker. Some would probably say "its already easy" but at least with my caliper, the release button on the bottom gets slightly stuck.

I had to order this so I could get the Reekon to work with my saw. But works great!

Good

Excellent

Not quite universal. I have a Ryobi 7” miter and the right side of my miter (battery side) bumps on the fence when going down. I had to cut off about 2” from the top in order to make it work. Also, it’s a two piece design now so for whatever reason when I lined them center on the blade, they aren’t quite flat to each other so when you’re sliding material against the fence it’ll push it forward slightly. I did tighten the screws all the way in but you have to be careful as well because it’s mdf and even with the shortest screws it almost came through on the left part. That’s my experience with it so probably different with others since not everyone is using my miter but just a heads up. If the company made the piece one solid piece again and then had the right side of the fence lower than the right I think it would truly be universal.

Needed this to use the reekon M1 to use with my miter saw. Easy to install and durable! A little in the steep side for price but overall a good product

This is an adapter piece I purchased to make the M1 Caliber work with my Ryobi cordless miter saw. Unfortunately, it blocks my miter angles, making it impossible for me to angle my blade for miter cuts. Worse, this adapters has to be screwed on to the existing fence, making it difficult to remove and replace.

Der Spaß ist aus MDF / Holz und der Aufdruck ist alles andere als präzise, zuerst bin ich sogar von einem Fake ausgegangen. Ich habe das ganze behalten, da ich u.a. einen Ansatzpunkt für eine digitale Messeinheit brauchte, kann aber keinen Kauf empfehlen. Das Ganze kann man sich auch wirklich einfach selbst basteln und präzise Schnittpunkte einzeichnen.