Detroit Axle - Front 12pc Suspension Kit for Nissan Titan Pathfinder Armada INFINITI QX56, Outer Inner Tie Rod Ends Boots Sway Bar Links Upper Lower Ball Joints Replacement

This kit was AMAZING and a perfect fit for my 2010 Nissan Armada with 208k miles on it. My old steering was completely worn and sloppy and noisy. Everything was a direct replacement and was the correct size. All the nuts/bolts/pins to replace everything WERE INCLUDED in each little package. Firestone aligned my Armada today with no issues and it drives like new! I had numerous rattles and knocks going over even small road bumps that are now gone.I do have a couple of small suggestions though to help your install:1) Use plastic zip ties for the tie rod boot at the top. I didn't like the metal bands included in the kit and there's not a lot of room up there to try and clamp that metal band together.2) Save the lower clamp boot ring off the OEM tie rod boot to reuse or use another zip tie on the smaller bottom end of the boot.3) If you need to replace your upper A-arm/s (you probably do because the bushings are bad), the new Duralast upper arms comes with ball joints already installed on it, so you won't need the Detroit Axle ones in the kit.4) Keep your lower ball joint safety rings from the OEM ones when you remove them and reuse them instead of the ones included with this Detroit Axle kit. I wasn't able to spread the new included safety rings wide enough to install them, even with the correct ring spreader tool or needle nose pliers5) Replace the sway bar rubber mounts while you're doing all this. You'll be down there, it's an extra 5-10 minutes, and you'll have the sway bar links off anyways. If you're replacing all these parts, your sway bar mounts are due too.I'm a total weekend wrench guy, I'd say like 4/10 skill level, and I was able to do this with basic tools from my garage. I had to rent a tie rod removal tool kit and ball joint tool kit but Autozone had those. I'm know that I'm SUPER lucky that I live in Los Angeles and my vehicle has never seen snow/salt. Everything came right off with a breaker bar.

I was concerned since all the parts I ordered from Detroit Axle were literally about $1000.00 cheaper than my local parts store. I would normally not cut cost on suspension parts, but sometimes you have to do what you have to do. I got these and first thing was pleased that all parts were the correct parts. During installation, the boots on the ball joints popped off. Not a massive issue, but aggravating none the less. I got them to go back on and hit it with a pump from the grease gun to make sure. Everything else went together perfectly. I also order wheel hubs and they were perfect also. Been driving the wheels off the truck going on two months now and no issues at all. Steering is really solid and it feels like a new truck again.

Great value for the price, only drawback is the lower ball joints are sealed non greaseable. Still can't beat the price for a 10 year warranty.

The kit was exactly as described and everything fit perfect. I had to buy different sway bar links because I have a 6 inch lift in my Titan and these links are for factory ride ( no fault on Detroit Axle, I knew this when I bought the kit ). I gave the sway bar links to a friend with a Titan that is still set at factory and he installed them and they work great as well.

This product is legit. To oem specs, arrived timely. Install went great. Will update on durability.Update: 1000 miles later, still going strong. No complaints

Just as good as OEM. 04 Titan 160k

Upper ball joints seemed to be machined wrong

The media could not be loaded. 10 year warranty is great if you don't mind doing the job every year ?? These parts are for car lots only to sell a vehicle not worried about longevity