Company (Snow) Digger Rear Hitch Snowmobile Rear Hitch Universal

It’s a good quality light weight hitch and I think it will work great. If you have a straight rear bumper, it will be a piece of cake to install. My bumper is angled (bend in middle), I knew this when I ordered the hitch. I used my Vice to slightly bend the small angle brackets and then bent the backside bar. It’s not perfect (you’ll notice I didn’t center it well) but the aluminum will bend without compromising the hitch—it works. The manufacturer and seller probably would not recommend doing what I did, but I’m a little hillbilly…so yeah, there’s that!Good luck!

I had to return this as it would not fit the sled I was going to put it on. I do wish this would have fit thought. it was a very well-made universal hitch, and I probably could have made it fit. its design and build is great and once you have it mounted, I would expect you would never have any issues with it.

Being a cheap product, you can pretty much expect that the pre-drilled holes don't line up quite perfectly....and they didn't...but who cares? If you're wanting to keep your man card, pull out your drill, and make it work. I'm probably also going to have to make the hole for the ball bigger as well, because I need it to be able to pull my snowmobile trailer which takes a 2 inch ball, and they don't make any with dinky little threads to fit this hole. Once again.....who cares? I'll make that work too!

Good product assembled and drilled bumper . Mistake, needed to use the drilled backing plate as the template to drill the holes. Made it work , would have been easier to us the flat backing plate .

Garbage. Broke towing a light sled first time out.

Easy measured and drilled two holes through the rear snowmobile bar handle and tightened up and this works great to haul my ice fishing sled! Very heavy duty and secure. Tried the U-shaped bracket thing available on sites and that was a waste of time, returned it.

had to round edges, other wise it s good

Installed on a 2003 Polaris pro x. Should fit any snowmobile with 1 1/2", or more, flat bumper. Easy to install by drilling two holes and bolting in place.