AUDEXEN LED Strobe Brake Tail Light Rear Motorcycle Taillights Compatible with Harley Dyna Sportster Road King Fatboy Electra Glide Heritage Softail Touring Sportster

Worked nice took a little while to figure out the wires it come with a plug but you have to insert the wire ends. Looks good and functions like it is supposed to

The light looks amazing. I do not like the fact that the license plate light is facing up and in my Harley the license is in the bottom. Aside from that it looks amazing.

Perfect fit . Little tricky to hook up . But lasted a few years and was done .

Fit well

02/06/2021-I mounted this LED light on a 96' HD FLHTC. GREAT SAFETY IMPROVEMENT. Conversion required updated light backplate. I used a Custom Dynamics TL-B Taillight Base Plate (Mdl. Yr. 1999-2016) the part included the back gasket (This was a Amazon return so only $18.26). You can try same or source used EBay or HD OEM. First I cutout the bracket inside the opening and painted cut area. Set the backplate to relocate 2 top & bottom mounting holes outside of opening. Drilled where marked in pic #3. I used phillips-head #8/32 X1.25"L SS screws with 11/32 nuts. (NOTE: USE LOW PROFILE SCREW HEADS) Did not use plug end. Trimmed insulation bike wire back 3/4", slipped on heat shrink and slipped wires into each light fixture terminal ends (about 1/2 of braided wire end). Folded back wire, spun remaining braid around terminal and slipped over heat shrink and heated for complete termination. Wire match B.red-yellow to L.red, B.blue to L.purple and B.black to L.black. (B=Bike, L= light fixture.) NOTE: Backplate to Lens requires (2) #8/32 X 1"L mounting screws. You can use OEM as they are course thread. Test wire before proceeding with modification to ensure light works on brake-running & license plate. Some customers reported license light didn't function and seller will exchange.I'm very please with this modification. Better than original factory lighting. I hope this helps others considering this with an older bike.

Installed on 06 HD RK.Piece of cake, just follow wire colors of your old plug for correct position, arrange wires in that order, insert wires into the plug provided, could not be easier.

Did not fit properly

This is a smoked out 3 talon Screaming Eagle tail/brake light. it fits my 1999 FLHRC/I. THhis light blew out my front and rear turn single as well as the 15 amp fuse. i replaced the fuse and bulbs and the turn signals in the front stayed lit and the rear signals would not come on at all. i then replaced the bulbs again and the signals all worked;however the rear running aspect of the bulbs stopped working. i have ordered new led s stage bulbs in hopes that this will resolve my issue. The light looks and works fantastically. it is an easy install, no must no fuss.