🚀 Tune Up Your Ride and Feel the Power!
The KIPA Carburetor Calibration Tuning Kit is a high-quality set designed for precise tuning of CFM 1400 series and Carter AFB carburetors. It includes various springs, metering jets, and rods, ensuring compatibility and optimal performance for your engine. Perfect for both novice and experienced tuners, this kit is essential for anyone looking to enhance their vehicle's performance.
D**S
Complete fuel air ratio kit
I was concerned my mopar was running to lean causing over heating. I switched to the smallest diameter rods and increase 1 size stiffer spring. Did not change operating temp, but did improve stab from idle to full throttle.
S**R
Close but......
Parts are close to what I have but not exact. So I'm assuming that's why my carb isn't working as it should.
B**Y
Ok product but box was busted open
The product is good but the box was open and all pieces were all over the place inside the shipping box
C**E
Quality
As good as edelbrock brand, at a fraction of the price.
C**K
Good kit to have. Has several correct size needles, springs etc. Everything needed and all the jets
Rebuilt a 650 carb and thanks to the seller and honesty it work perfect. You truly can't go wrong with this kit
M**N
I had no idea it would be this bad! Nothing is marked.
Even though the photo shows the ids on the jets, no such luck with the actual products.To use these, you need to spend money on precise measuring tools. Do you have, .101", .098" and.095" drill bits? Or a caliper that can differentiate between .073" and .070"?And you'll need to jump through those hoops again when you need to change your jets. Sure you brought along the jets and rods, but did you remember to bring your caliper?Unmarked jets in your carb. What could go wrong?
A**R
Chinese junk.
Very cheaply made jets don’t match or labeled to its size. Better off paying extra and getting an original kit.
J**H
Not a tune kit.
Two sets of rods were no different in size than what the carb had stock and all the jets that came with the kit were the same size, save your money and buy a proper Edelbrock kit. if you just need some basic rods for an old carb and some jets to solder shut and drill out I am sure this is your kit. But don't waste your money otherwise.
A**R
Not great
Metering rodes bent not made as good as edelbrock ones
S**H
Over Priced
Kit is nice to have But takes time to dail in.
C**S
Don't waist your money
Junk dont waist your money nothing has part numbers on it and none of the springs are colored
J**Y
Parts not there
When i opened the package some of the parts were missing.