Caliber Marine Trailer Bunk Slides 23011, 3 x 15 inch, 10-Pack, White

Bought these for my husband for our boat. The water is low again which makes loading/unloading tougher. It was noticeably easier this year.

These pads worked extremely well.

Could use at least 2 maybe 4 more on my 22' boat trailer but should work ok.

I have a 20ft deck boat that is on a trailer with carpeted bunks. It has been a real hassle at the ramp getting the boat to sit right on the trailer. Part of the issue is the ramp is very step and the front is very high on the double front roller. I had to force/jerk/manipulate the front into position. Once out of the ramp I could not pull the boat on the trailer with the winch. There was too much friction. NOW after the slides were installed I can get the boat in a decent position on the ramp and then haul it out. Once out the boat is sitting in the proper position I can crank the winch to bring the boat onto the front rolls with little effort. This is something I could not do with the carpet only bunks. So far great product!

I mounted these on a Tracker boat trailer that was a real pain to load my boat on. Now the boat slides in easily and if it's off centered, a slight adjustment with the engine and it lined up with the winch. Never been this easy to load by myself before. I can also finish moving the boat on the trailer if needed after I get it out of the water.

Great product. Significantly reduced friction between the boat and the trailer bunks. Much easier loading and unloading the boat at the boat ramp. I have owned and operated all kinds of power boats for 35 years. I recommend this product.

Used these on resin coated wood to replace the bunks on my boat trailer. After just a few uses they seem to be covered with paint from scratching the bottom of the boat. The screws are all down far enough none should be hitting. It is an older boat so there is a chance the paint was already damaged from the previous bunks. But these still seem to be removing some paint.

I've own several boats in my time but this one had me in a ruckus. The old carpet bunks made this boat nearly impossible to load and its just a 17 ft center console aluminum. TO get it all the way on the trailer I would haft to sink the trailer. Then if I didn't have someone with me to drive up, well I got wet every time. When I installed these I notice a difference, First, it fell in the center as it should and then I didnt haft to back in the water as far leaving enough room to get out of the boat without getting wet. it now drives right on the trailer. JUst buy them if your having trouble loading ur boat!

Easy to install , works great and reasonably priced

I ordered three sets, to allow me to complete two trailers. The installation was straight forward. I found that pre-drilling the pieces was the best way to install the slides.Loading the boat (20 feet long, weighing approximately 3800 pounds) was considerably easier than previously onto the carpeted bunks. As well, loading my Yamaha Wave runner onto it's trailer was a snap. I did not have to submerge the trailer, as before, and winching the Wave runner was a one hand operation.I had spoken with a representative at the Excalibur and they were very informative and professional!

I installed the item on my trailer. It was easly installed and the boat was much easer to ramp it onto. The boat is winter storeage , This spring I will determine if it is as easy to unload as easy as it was to load the trailer.

YES ALL GOOD, VERY NICE PRODUCT

They were installed in the fall so I haven’t had a chance to try them yet . Installation was a breeze with the stainless screws supplied . I’m looking forward to trying them !