Forward Reverse Remote Control Switch,AC110V-250V Linear Actuator 12V Waterproof Remote Switch,8A Relay Receiver Controller with Control Range up to 165 Feet for Roller Shutter/Crane

Really good quality. They work reliably and are easy to set up. The only problem is that the range is so so. I am using them in jog mode to move my solar panels and I have to be pretty close for them to move them as I hold the buttons down. Easily fixed by opening them up and letting the antenna hang out of the water proof box.

Works great for any plug in tool or appliance.Used on a water fountain pump. Works great! I will also use it on my woodworking vacuum. Easier then walking to the vacuum to turn it on each time.

I purchased two. Both seem to be wired correctly (see attached picture). Had some issues with the remotes crossing between the two units. I reset each of the units by pressing the remote key for ~10 seconds. Then pair each remote to one unit (plug the unit to AC, within two seconds hold the ON key until you hear 3 beeps, OFF key until you hear additional 3 beeps). Works OK for the last couple of days. Happy so far.

CAN PAIR MORE THAN 2 keychain transmitter clicker FOBs to each receiver box!!! So if you buy MORE of the exact model switch with _IT'S TWO_ transmitter FOBS I have been able to pair FOUR FOBS to ONE Receiver box! These are super simple and easy to pair ADDITIONAL clickers for even more versatility! You will then have the 2nd BOX as a spare, while using all FOUR fobs paired to the IN-USE receiver. IT might take over 4 but I only have 4 now.

The cover plate on the switch is labeled "output" & "input". However the printed directions show the opposite labeling.... I'm using this switch to power a linear actuator.Putting power to the output pops my circuit's fuse. So the cover plate printing must be correct, and the printed instructions incorrect... yes??Also, one of the units will not pair with it's remotes.Neither unit has the number of audible beeps to confirm pairing status that the instructions state, when holding down the buttons to enter paring modes... It's impossible for me to know what state the remote is in when attempting to pair.Also, what does "interlock" and "jogging" mean? I can guess at this, but neither seems to do as it is indicating.Finally, when I did accidently pair remotes to one of the units, the down arrow on the remote extends the actuator, and vis versa. Is "jogging" the ability to program which arrow button does what? I need the opposite of what it's doing.The instructions are rather poor in my opinion, and I'll likely have to return these two units that I purchased.I'm hoping the seller or manufacturer will reach out to me and articulate which side is truely input and output.Meanwhile my time-sensitive project is ground to a halt. This is frustrating to say the least.I'd contact the seller directly, but I'm not seeing that option via my Android phone app.

Built a remote power source for operating awnings or other 12 volt devices. Used this remote control switching device so the power is controlled by the fob

Put on my dr power grader, works great!!

Works just as it shows you.