CamcoRhino Camper/RV Replacement Tote Tank Rinser - Features Integrated Water Inlet w/Multi-Directional Spray & Backflow Preventer - Fits 15-Gal, 21-Gal, 28-Gal & 36-Gal Rhino Tote Tanks (39022)

The hose that came with my blue boy was very lightweight and cheap. It developed pin holes by the 2nd or third time I used it. I tried repairing it. But it was a disaster. It came apart in pieces. My regular black water hose is a Rhino and works great! The first time I used this to transfer black water to the blue boy and then to the septic was easy clean! It's worth the couple extra dollars to get this heavy duty product!

Was super easy to install on our Ameri-Lite bumper, sturdy and strong. I used ratchet-straps instead of the included straps. I have the BIG honey tank and it holds it solidly to the bumper without hitting the camper wall.

Works like a champ.

It looked like a simple installation but as typical of my projects I ran into a little glitch...not too serious but a little annoying. The base of the two stand uprights are supposed to lay across the top of the bumper and extend back a little way under the camper body and then the u-bolts go over the part lying across the bumper and secure it to a steel plate under the bumper. This assumes that the bumper either sits far enough back for the upright to have enough room for the u-bolt to fit before contacting the rear of the RV or the bumper is low enough that the upright will lay across the bumper and extend under the RV. On my trailer the top of the bumper was about even with the bottom of the trailer and close enough that there barely was enough room for the u-bolt to fit behind the bumper. With the rear u-bolt in place it was so close to the end of the upright that it would slip off while tightening the bolt. My solution was to install a bolt on top of the upright near the end to serve as a stop to keep the bracket from sliding off when tightened. See attached pics. That worked fine. The black paint on the steel plate that goes under the bumper was flaking off in places so I am sure I will have to touch that up to prevent rust. A couple of cam buckle straps were provided but I could not get them to hold as firmly as I like so I will be adding some better ratchet straps. Overall this tote carrier seems sturdy and well made and I am satisfied with it.

This is perfect for accurate measurement of sewer tote contents!Highly recommend!

Works great no leaks

I was going to secure my tote tank to my ladder, but opted to get the bumper mount instead. This mount installed easily. Before fastening the bolts tightly, I recommend putting your tank in the mount to make sure you have the right width set. I like the mount has loops to pass fastening straps through to secure the tank. I have a cable lock to keep my tote from disappearing and found the cable works nicely with the mount.This turned out to be a great purchase. I also use a cargo rack with my rear bumper and have not had any issues with tank or mount getting in the way.Two thumbs up!

Works good

Great wheels! We used them for our rabbit hutch tractor. Good quality. Thanks!

Réserve d’eau noir

tres utiles

Exactly what i ordered. Good quality.

I have the 28 gallon Rhino tank, bought without the wheel kit. I found it very heavy to move around, doing my back no favours. So, even though the wheel kit was expensive, decided I had to go with it. The kit is very well built, quite robust. The only complaint I had was one of the wheel retainer clips was missing. But, a quick email to Camco resulted in a speedy reply. They sent me a new clip, which was received quickly. So, a high quality product and great customer service, just wish it'd been less $.