Oregon16" Reversible Single Rivet Guide Bar, A041 Motor Mount, 3/8" Low Pro Pitch, Gauge .050", for 56 Drive link chain

I liked the blade. It fit perfect. The delivery however was terrible. It was a miracle I received it. On Amazon it says left in customers mailbox. One of my neighbors about 1/8 of a mile down the road brought it to me. Said he found it on the road in front of his house. Might want to pass that along.

It is what they say and works as it should

prefect fit

Good product, good price.

Very satisfied.

I was gifted a model 358.351060 near antique chain saw.Replaced the spark plug.mixed high quality fuel with red armor echo oil additive at proper ratio in a one gallon container.cleaned the reusable air filter, then took it for a spin. after a few uses, the chain jumped off the bar.I may have over tightened the chain, as the sprocket collapsed.I have used oregon bars in the past, so this was an easy choice.the spec of the chain and bar labeled right on the chainsaw handle gave me the specifics for replacement.I just need to ensure I do not over tighten and flip the bar every so often to create even wear.A lot of torque to those old craftsman saws,

Replaced this bar with the original one for my old Remington 16 inch 56-link electric corded chainsaw. It works much better than the replaced one although the price is a bit high. This bar actually works with almost all models of on-market and after-market 16 inch (0.050-Inch gauge and 3/8-inch pitch) chainsaws. If the distance between the gear/sprocket and tension holes differs from using the original bar, we can set the bar/chain tension with the tension adjuster of the saw or using a 55-link, or 57-link, chain.

OREGON IS MY PREFERRED CHOICE . . . . . . ALTHOUGH , I thought I was getting an 18" for my Stihl ... this one came and I just did not have time to return it and get wood cut for the cold coming on .......There is MOST ALWAYS a method ............ Great thing it was an Oregon ..... it had a roller nose wheel, and the gauge was good ........ it just was 16" , I had 16" chains ..... and it had an extension on the tail that I cut off and drilled the oil holes .................................. it has worked great for a month now of HARD cutting time ....... but then , it is an Oregon.

good

Using this on a Makita DUC405 with Oregan chains to replace the narrower Makita original. Used on ash and elm trunks up to 30" diameter.

Los materiales de construcción son demasiado buenos para el precio que tiene.

produit conforme a ma demande envoie rapide, très bonne qualité prix

hab bei meiner makita dieses schwert mit einer etwas stärkeren kette eingebaut. problemlose montage. funktioniert bestens