621 Magnetic Portable Charger (MagGo), 5,000mAh Wireless Power Bank with USB-C Cable, Magsafe-Compatible Battery Pack for iPhone 16/15/14/13/12 Series

This was my first Magsafe battery. I had some older Qi wireless chargers and was familiar with heating issues. But these were older and lower power. Without the Magsafe feature, they were finicky and fussy and didn't properly fit around camera lens protrusions. I barely used these devices. This Anker 621 has a lot of promise. The Magsafe feature locks tight and the dimensions do not interfere with the camera protrusions, even with a case on the phone. It's compact and slim, and most importantly, does not require wires. It can be easily carried in a backpack or pocket without an accessory bag for wires and cables. When I first unpacked the battery, I fully charged with with a USB-C PD charger. It charged at 1A/5V. I used it to inductively charge my iPhone 14 Pro intermittently over the next few days. After about 10% charge, I determined the heat buildup to be intolerable. Therefore, I only used the pack intermittently. That worked fine for me over several days. When the battery was empty, it took 20Wh to fully charge. The battery was advertised for 5000mAh, which is impossible to measure without disassembling the unit. However, we can calculate 20Wh / 5V / 0.9 = 4400mAh (where 0.9 is the efficiency of the voltage converter for USB). This is below advertised capacity, but there’s a lot of assumptions in the conversion. Then I used a USB-C cable to charge my iPad Mini. It transferred 14.8Wh at about 9 Watts before exhausting. The round-trip efficiency was high, because recharging took 14.8Wh to fully recharge. I suspect I didn’t get the full 20Wh capacity with the iPad because the higher charge demand choked the battery before it could get fully empty. Using the inductive charge mode, both devices get hot relatively quickly. The switching power electronics get particularly hot. I can easily feel where the transistor is located beneath the plastic shell. The inductive transmitter loop gets warm on the battery and the receiver loop gets warm on the phone. Lithium-ion batteries degrade proportionally to temperature (the Arrhenius relationship), accelerating +25% degradation rate for every 10C, this is bad for the phone. In summary, • The battery delivers 20Wh of energy. If using inductive (Qi and Magsafe), much of the energy is converted to heat, so perhaps only 10-15Wh is actually delivered to the battery. • If using high-current devices using a charge cable, such as an iPad, the high current chokes the battery a bit early, stopping at 15Wh. • My back-of-the-envelope calculation shows 4400mAh vs. rated 5000mAh. I suspect the battery is not delivering rated capacity. Anker should be rating these batteries in Joules (watt-hours) instead of Coulombs (ampere-hours). • Inductive charging is inefficient, losing a quarter to half of energy to heat. This is not Anker’s fault but a result of real-world physics. With my iPhone 14 Pro, I saw about 10C rise per 10% of battery charge. I never let it progress beyond this point. • Lithium-ion batteries accelerate aging degradation due to the Arrhenius relationship about +25% per 10C temperature rise. Therefore, prolonged use of inductive charging will ultimately age your battery prematurely. • This battery is very worthwhile because I don’t have to carry an accessory kit with wires to use. Just slap it on the back of the phone and go. Plus, if frees the connector to use with wired headsets when using.

UPDATE 3/11/2026 - Anker absolutely honored their commitment to their product and issued me a replacement. They were quick to respond and to mitigate the issue I had with their product. Thank you ANKER!! I’m a huge Anker fan and a loyal consumer of their products, so this is the first time I’ve encountered an issue with one of their products. The charging itself works fine, the problem is that the magnetic charger gets very hot, which disrupts charging until the temperature drops. I have another brand with the same specs that doesn’t have this issue.​​​​​​​​​​​​​​​​

I’ve been using this Anker charger for a few weeks now and it’s been great. It charges my devices quickly and feels really solid and well-built. I also like how compact it is, making it easy to carry around. Definitely a reliable option if you need a fast and dependable charger.

This battery has honestly changed the way I travel. It only charges my battery up to 70% but for me that’s more than enough. The slim design makes it easy to carry to the point I don’t notice I have it in my pocket. I’m giving it 4 stars only because the battery does get hot but besides that I like it

Just received this to replace another same type battery but that one would go on then just shut off for no apparent reason. I do have an IP-12 and i use a pretty heavy case so i wasn't sure how these type of batteries were going to work. I installed the metal ring on back of case and as it held battery ok it just wouldn't charge. So i bought this Anker to try it as i do like Anker batteries. Well right away it stuck right to my case and immediately started to charge. I was still skeptical. I just waiting to see if it shuts off and it never really did. Yes it gets warm just like the other battery, but that's the characteristic of this type of charging. But I have to tell you this thing grips much better than the other battery I had, maybe it has something to do with being a MagSafe battery I don't know that's why I wanted to try the Anker as its not a Magsafe but a Maggo and boast that it has a much stronger magnet, and I can Contest to that. It's not the fastest charger but it does charge. It is probably taking me an hour and a half hour to go from 60% to 95% for me that's OK. It's meant to be more of a rescue battery to basically get you through the rest of your day, my phone that has relatively small battery. This battery probably would charge it fully but The newer phones have larger batteries. This probably will maybe get you 80% which is just enough to get you through the rest of your day. Yes, heat is a factor and some people complain about it and some people understand It's a necessary phenomenon in this kind of charging, this case with the heat temperature gun i saw 134 degrees at its peak but it does go thru cycles of heat and cool as internal thermostat kicks in. To me thats a minor inconvenience, but it does not heat up your phone. The heat stays within the battery itself and it does not radiate to your phone. So far so good i using it now to write this and as the charge percent is not rising as fast as it did when I wasn't using the phone. It's basically holding the percent at one particular spot right now. So in closing, if you have a heavy duty case, try it, it might work get the rings and put them on the back of your case and see what happens. My rings came with a template which is not easy to use with a heavier case so what I did is I attach the ring to the actual battery And I moved the battery on the back of the case where I found a nice spot where the phone always went on charge every time I hit that spot and then I remove the plastic on the ring went back to push the battery down on that spot removed it push the ring down by hand make sure it was good And that's it, sometimes that's more accurate than using a template. I do agree that the thickness of the case plays a big roll in whether this will work or not, but what do you got to lose if it doesn't work you can return the battery or buy a new case that's thinner and will work better.

I love anker products but this one is where I feel like they may have missed the mark. It runs very hot & charges pretty slow, I am not sure if thats just something that happens with wireless chargers however I am just not a huge fan. This charger is small and super easy to use, does what it is supposed to. It also has a good value. But at the same time, out of all the portable chargers that I have or use, this one is the one I use the least. It only really charges your phone one time, the portable brick chargers with the plug ins are just better.

Lo compré para mi mujer y está muy contenta con la batería externa. Trae suficiente carga para recargar su iPhone una vez (y sobrarle algo). Al ser pequeño y con MagSafe, pues cumple con todo. Buena calidad de construcción

Nice and small, does only give around one full charge and the phone tends to get fairly hot though. Magnets are plenty strong, certainly wouldn’t drop off but it can rotate on the phone if it’s in your pocket or something. Feels decent quality too, doesn’t feel like it’d break easy

Product is light weight and slimmest powerbank in the market. material feels very premium. Magnet has good power to hold the mobile.

Amazing and I love the colour. I can even use it as a wire charger for my AirPods and not worry about it sliding off the patch it has magnets

Rekomenduję , super