STAR-SPANGLED 3 Pack 2.8” Motion Sensor Lights Indoor AAA Battery Operated, Stick on LED Puck Light for Stairs, Under Cabinet, Closet, Cool White

I installed these up a dark stairway. The motion sensors are sensitive and the light turns on for 20-seconds. The light is a bright white so it makes it very easy to see the stairs. I highly recommend these if you are looking for a good motion sensors light. They are just the right size and work well.

Works great. Bright light. Hang waist or lower or light is in your face.

Works good but one of them keeps falling down. Light is great & just right brightness.

These made the difference! My mom wanted light inside her cupboards so she could see. I purchased these for her and have to admit they work!! Bright enough and will last long on the batteries. Highly recommended.

Just what I was looking for. I placed one in the hallway and one in my gbabies room. They work great and the light is bright enough for me. The adhesive has worked well and the light has not fallen off the wall. They are very easy to use just attached the three triple a batteries and stick them to the surface.

I loved these puck lights out of the box. They were packaged well, a very good size and easy to open to install batteries. They are solid quality and very bright. They come on briefly when the battery is installed and then go out in a few seconds and are ready to mount. The adhesive on the back of these is fierce, to the point that after being on the inside wall of a cabinet, I had to pry the light off with a knife to move it. This left most of the adhesive stuck to the cabinet ( now the light has no adhesive) to scrape off and it leaves a sticky residue. If I had expensive cabinets I wouldn't use them - DO NOT USE ON DRYWALL if you don't want to spackle and paint because they will remove both paint and drywall in removal. Make sure you know where you want these before attaching them! Now, the reason I was moving them. They really aren't sensitive at all unless in total dark. They would work very well outside at night or moving through the house in the dark, but my use was for deep unlit cabinets that I've had to shine a flashlight in to access items. I will seldom be in the kitchen completely dark so that they'll activate. This has apparently been a problem because I received an email (thanks, it helps!) with instructions that included use in other than pitch dark. Apparently I have to open them and partially cover a sensor. I'll be doing that and review if it was easy to do and worked well. If not, I'd advise a different light.

The lights work very well, they are motion sensored, very lightweight. You can put them anywhere and they can be stuck in your closet on the wall. Great value for the money, you get three of the small lights in a package, they're pretty bright as well. They take three AAA batteries. Very easy to use. I'm glad I bought them. Also to know, they're aren't very large, about the size of your palm.

What a great find! I needed a light inside my large mailbox because I can't see anything when I check it at night. This little light is perfect. It's off until there is motion detected then it clicks on. You need 3 AAA batteries in each, but they work perfectly. I'm buying more

Put on a dresser drawers to stop us walking into it at night. Works great and lights the space up well too.

Works well, and is perfect for homes with senior citizens. I wish the sensitivity to light was a little lower. It gets activated in fairly good light, which is basically a drain on the batteries. And yes, I don't need the cashback for the rating :)

Batterien halten sehr viel länger als die Modelle, die ich auch als Treppenstufenbeleuchtung verbaut habe.

Perfect

I've turned this into a bit of DIY project. Before spending couple hundred bucks on replacing the latch in my car's trunk which fails to turn on the light (despite the light bulb being okay) I decided to try this. The idea was that it would only turn on when it's darker, when I open or manipulate things in the trunk. It turned out the light detector would only turn on the light when it was very dark, so I did a little modification. After opening the back of the product and removing a few screws you'd see a printer circuit board with one chip, 6 LEDs, motion detector in the middle and a light sensor on the side. I gently painted the sensor with a permanent marker to darken it (not to make it entirely black). That made the light turn on earlier, when it was in a dark shade, not just a complete dark. I also cut one of the circuits on the board to disable 3 out of 6 LEDs since I found them to be much to bright for my needs, considering that perhaps this will extend the battery life. I mounted it in the my car's trunk and so far it has worked as expected for about a month now. We'll see how long the battery lasts, especial in cold weather but overall I am very happy with how it works. Good product!