Project Patio1-1/2" Wrought Iron Patio Furniture Feet Caps - Round Plastic Outdoor Metal Table and Chair Floor Protector Glide Replacement Parts (24 Pack)

-Worked out great. Didn’t need soften them up - but left them in the sun on purpose while scraping out the original ones with a paint scraper followed by a stiff bristle brush to ensure all the dirt / pollen was removed. Did six pieces/24 legs without any issues.-While folks recommended pliers to fasten, i didn’t need them. Instead, once i was able to get them attached i’d flip the chair / table back over and use the rubber mallet method with a block of wood to avoid damaging the paint and to have them permanently snap in place.-I did have one deformed metal caster so I ended up siping one cap to get it to insert… then tapped like the rest of them.-So, _rubber mallet or sledge, _block of wood, _box knife, _stiff bristle brush, and a _scraper. Easy work- :20-:30 min tops for all six. Would recommend to anyone.

Heat them in hot water put them in the center and smack it hard with a hammer. They work well. Some don't go in easily but once you get the hang of it. They are great!

Perfect fit and quantity packaging options for any project. Installation was simple and straight forward. Will be ordering additional products from this US based company.

All but one tapped easily into the bottom of my 1 1/2" ID chair and table legs cup. Product not at fault, the bottom of the leg had a little bit of wear ( Internal Burr) from not having a cap for couple of yrs. All I had to do was de-burred the ID of the leg and the cap then installed correctly. Not as thick of material as I thought they would be. My Original leg and table caps are15 years old and only 8 of 20 of them needed replaced. Have to wait and see how these wear on Cement patio..

These replacement pads worked perfectly! They were easy to put on, just tapped them with a rubber mallet. They're the perfect solution to prevent our wood deck from being scratched from the iron feet of the chairs and table.

A fantastic exact fit for old rusted outdoor chairs that were leaving marks on the rug. Using a dremel to knock off the rust helps with an easy installation via a mallet.

Like many other comments, these were somewhat difficult to install, but with the aid of very hot water and a small hammer they went on satisfactorily. The issue I'm having is the lack of traction between the new chair feet and my deck - there is none which I feel is a significant safety hazard. I might try scuffing the feet with some fine sandpaper.

Perfect fit! Chair legs now move smoothly across the floor thanks to the perfect and durable fit. Thanks a bunch