RuffStuff Specialties INSTEER Steering Knuckle Insert (2-Pack) for GM 1-Ton Tie Rod End Conversion

Fits GM one ton steering conversion for jeep jk. Will need 7/8 drill bit to drill stock knuckles.

I used these to put WJ brakes on a Jeep Cherokee with one ton tie rod ends. I drilled out the knuckles to accept these. The Jeep goes straight and these work perfect. I didn’t weld them in, just added a bit of loctite.

Cant give this enough praise. Had a bad knuckle that was hard to find, useing this incert saved me hundreds of $s. Everything is a tight fit again.

Did what it needed to do no complaints

Worked well. Used in Kubota tractor...tie rod end. L3300 Kubota

The guy that left the one star review was a dingle berry it's supposed to be set in a little this allows the tie rod to tighten up completely. They work great no complaints.

Absolute garbage, they aren't long enough to cover the full knuckle thickness. They don't make full contact on the tapper of the joints.

So after following the instructions and drilling too listed spec it did not fit or work properly... reamed tell I felt uncomfortable going any bigger. Even after drilling more then what was specified the tierod end wouldn't come up enough too get the coder pin in properly..... now I have to buy new assemblies and have them reamed for the tierod ends..... I feel super sketch driving it like this. Just get a balljoint reamer or pay too have someone do it properly