Tobacco cutter for cutting tobacco leaves or herbs Cutting width 0.8mm

It's shreds T'bacca, and it does it very well. It's also very satisfying to see it take in leaf and spit out shredded tobacco. I'm tempted to shred other things, I'll have to think of something if I ever run out of leaf.It's almost like a tobacco version of a car crusher, which is also fun to watch.

Absolute garbage. Don't waste your time on this one. It has a tiny bolt that holds the handle on and makes the blades turn. Bolt is made of the cheapest pot metal they could have found. Breaks within ten minutes. This was the third grinder I bought from this company. Similar problems with the other two as well.

Works great. Whole leaf untreated tobacco spreads up perfectly.

Look like quality is good but your packing is so poor, it did come on time but one part was broken , so I ordered a replacement one will see when it comes. If you can put it in a small box with little protection will be nice.

The media could not be loaded. I could feel the quality of the product as soon as I had it in my hands.

this tobacco sheader does shread tobacco very well but the holder that screws on table is stripped and won't tighten up

As others have noted this shredder gets the job done, but there are frustrating design flaws that make it harder than it should be. The arm that bolts to the table isn't long enough and the angle makes it awkward to use. The rotating handle hits it when you turn the blades, but straightening the arm out just made the whole unit be oddly angled because I'm not strong enough to bend the clamp part. Also, they seem to be totally out of the .08mm units, because I too received the 1.1mm unit. It's fine, I don't really care, the shreds are thin enough for my needs. All in all, it gets the job done and is a good solid unit for the price. It's pretty much the only choice out there, so it is what it is.

I've been using it since Early February 2023 - so over 4 months and it hasn't clogged up once. Doing everything else the same way so I don't know why but that is what is happening (or not happening).Other than that I think they could do better with the strength of the metal of the winding arm, it's too easy to bend and wear out or break. I know enough to be easy on it but I would like it better if it was stronger metal. (Just a Note for improvement).