AUFER Vehicle CB Raido Mic Mount Passenger Grab Bar Holder Microphone Mounting Bracket for Jeep Wrangler JL 2018 Up

This holder is less expensive than other options and it's very well made. It took all of 5 minutes to install and it looks great in my 2019 JLU. One should note there are no instructions included, and the ones in the description are not that great. For a 2019 JL, this is the process:1. Use a trim removal tool to remove the dash panel below the steering column (as this overlaps with the upper heater control panel).2. Unsnap the upper heater control panel (has the start/stop button, radio dials, etc. on it).3. Once the heater control panel is removed, it exposes the 10mm bolt holding the passenger grab handle on. Using a 10mm socket, remove the bolt.4. VERY GENTLY and only slightly move the passenger grab handle forward just enough to position the holder's round end over the back part of the handle and reseat it into place.5. Replace and tighten the 10mm bolt. Replace the upper heater control panel, being careful not to pinch any of the wiring behind it. Replace the trim panel below the steering column.That's it - very simple!

This is a sturdy CB mic mount and works great. To properly install it (it came with no directions but found them for a similar mount) you have to carefully unclip the center climate control/stereo knob panel to get to the left grab handle mount bolt. You have to loosen the grab handle bolt and slide the large hole in the lower mic mount over the grab handle mount and bolt it back down. Then carefully push the climate control panel back in.

Fit and finish are great.

CB mount for my 2019 JL. perfect. lacking instructions so viewed Youtube

Have used it for a few months now with our ham radio. Works great. Easy to use even when driving the jeep on the trail.

This was easy to install and love the fact that it holds the mic tight! They even added a rubber stopper to finish the holder and gives it almost an “Apple” product finish. Very nice

Works great