Windshield A-Pillar Molding Trim Compatible with 2011-2019 Ford Explorer Replaces 926-450,926-451,BB5Z7803137AA, BB5Z7803145AA, BB5Z7803136AA, BB5Z7803144AA(Left and Right 4 Pack Outer and Inner)

2016 Ford Explorer XLT 4wd. Like most of this year, my pillar rubber had completely rotted away and made an annoying noise when driving above 40mph. I looked around amazon and basically all replacement pillar trims had mixed reviews. I went with this one because the L/R Inside/Outside 4-pack was cheaper than alternatives. I will say the following:-The holes line up perfectly.-The (inner piece) trim seals to the window well.-The (outer piece) cover fit is "fair". But I can't deduct stars because I don't know if that's because of the manufacturing or because of my own technique. There's a little play in installing the inner piece, and in the 110 degree humid sun of Florida I didn't really want to sit there and mess with it. Plus, once you sit the outer piece onto the inner piece the adhesive tar makes a seal against the inner piece rubber and it's pretty sticky and messy.-The adhesive tar that comes pre-applied to the outer piece is messy. This is one area the product could improve, it's pretty liberally smeared on the piece and you'll need some goo-gone to clean it up because it squeezes out of the trim piece and needs to be cleaned up once the install is done.-The outer pieces are fragile, when you're pressing them down against the inner piece clips you should use caution. I got to "smacking" it down and cracked it, but it's my own fault, and the crack isn't super noticeable. Overall, considering the price difference between this part and the OEM Ford part, I would say it's worth the concessions listed above, and therefore I can't deduct any stars.

Cheap Chinese product. The clips don’t line up correctly and when you install, it breaks.

Great quality just delivered it 30 min ago it’s already installed

Put these on a 2016 Explorer. The A pillar molding was rotten & falling off. The fit was perfect, but I would advise leaving the tape mostly on and gently pull it of after you have it all lined up especilly the top piece of plastic that fits into the hole at the top of the a pillar frame.

Easy installation and look better than OEM

Perfect fit and easy to install, I give it 4 stars as the upper rubber comes with a really bad double sized tape that came off immediately and therefore I replaced it with 3M. Other than that very good product for pricing.

Supposedly these are supposed to fit a 2009 team Yukon they don't I'm just looking at them in my garage sitting there doing nothing forgot to return them

fit and finish are as good as oem. and unavailable from ford as of 12/17/24