Cane Holder for Nitro Rollators with Flat Frame, Drive Walker Cane Holder, Adjustable Crutch Bracket for Wheelchairs, Rollators, Knee Scooters, Assistant Holder for Cane or Stick Users, Black

After reading reviews I was hesitant about ordering this item, especially after reading about F22 models. As the photos show, I installed the holder on the F22 I received from the VA. The top holder was not an issue, but the bottom holder must be installed close to where the upright portion meets the lower portion of the walker. As the lower frame goes from the front wheels back it gets slightly thicker and the bottom holder will not fit. It securely holds two different canes that I use depending on where I will be walking.

I got this cane holder because it was supposed to fit my Drive Nitro F22 rollator. (walker).The piece at the top takes some muscle, but it does snap onto the upper frame, but the bottom piece does not fit at all! It is nearly 1/2" too narrow.It's a joke - don't buy it!!!

Bought for Drive Nitro Sprint rollator. The two cane holders were made of rubber to firmly attach to the frame which is wide and thick. The surprise to me: each piece had a set screw in it to adjust to the angle of the cane when it was fitted into the holders. Also, a hex wrench was included with holders. For me, it was helpful to get my cane and navigate narrower aisles and return to my walker. Note on the cup to handle the bottom end of a cane. My cane has a three foot base which was a little to big for the cup. However, one of the three pads rested in the cup and held cane in place.

Searching Amazon for cane holder for flat frame walker this is the only one that came up. It is designed specifically for a Nitro walker. I have a flat frame Planet Walker, so I thought I would give it a try. It was too loose and of different geometry. I tried several modifications but finally gave up. Nothing wrong with the product, I just made a bad guess.

Way too hard to put on have other ones that work just fine these are just way too hard to put on

This cane holder works well for a cane with a regular tip. It will not accommodate the larger tip that I sometimes use. If you take your rollator on trips by air, take the cane holder off before you gate check the rollator. It will pop off and be lost.

This doesn't fit the Nitro Sprint model. Will fit the Nitro RTL10266. But since I have the sprint model, I am returning.

Everything came as ordered and for the walker perfectly.