YAMAKATO 16PCS Carburetor Main Jet Kit for Mikuni VM22 VM24 VM26

So I am new to the jetting world I did mods on my sons PW80 with the original mikuni vm. I removed the exhaust funnel, put a cone filter, and removed the oil pump. The bike did not run at all after those mods. After picking friends brains and researching the jets had to be the problem. These jets came in clutch!!! The fit a little tight but the threads never crossed. Bike runs perfect!

If you do any of your own engine tuning, just grab this. Having all these sizes in one kit is so much better than trying to track down individual jets. They’re machined well and fit perfectly, which made dialing in my carb way less of a headache.

In central Virginia 110 to 115 is good not sure what the elevation is. This works for Chinese vm22 clone btw

Does what is says and is what is pictured

Gets the job done but they where very tight fitting into my FVRITO vm22 clone. Once they are tightened up the first time they become alot better fitting afterwards. It doesn't appear to damage the threads on the jet or emulsion tube. Overall its ok but I just dont like having to tighten brass threads as much as I had to.

I bought this set because buying individual jets for a VW 34 PICT3 is expensive. These were a screw in replacement and has all different sizes. Works good for a Bug carb on my Honda Goldwing!

These main jets DO NOT fit the genuine mikuni vm22-133. The threads are not the same size my fault was not remembering that my jet was a hex head.

Fits a vm22 clone just need to be careful screwing it in. The threads aren’t perfect but if you work it slowly it will work

Worked great for my sons Yamaha TTR125

Excellent! usesd to repair JD 322 main jet.

Fonctionne très bien