Aomeya Motion Sensor Outdoor Security Light, 50W 4750 Lumen LED Floodlights with PIR Sensor, IP66 Waterproof Motion Sensor Outdoor Wall Light with Remote Control for Garden

Great light, very bright and easy to set up

Installed this week, the 30W light is very bright and with the handy remote is useful as a working light and security light. Fitting was very straight forward. Operation is simple enough with some time to experiment for setting on the remote. I have ordered a second light for the lawn area for night time badminton. Being able to simply turn on and leave on is a great addition. Bought on promotion at a fantastic price.

I purchased this item to replace the same item I purchased in April 2024. The Manufacturer states the item should last for 50,000 hours. It appears one or more of the LEDs failed. I am disappointed it did not last longer as it was set to switch on at night for 10 seconds. Easy to install and the included remote control allows for easy adjustment from the ground. I hope my original unit was a one off and the replacement will last much longer.

Great lights ,that good I bought 3

A good bright light.Great it had a remote once fitted no need to climb up ladders to alter settings.No fiddley buttons to try and turn .Sen sensor works well too.put up at least two months ago still working brill

Good and very bright

This light has only lasted about 6 months and most of the led lights are out and i can’t even return it says have to be returned within a month though it should at least have a years warranty maybe i just got a bad one

This really is nice and bright. and the remote is very useful. Downsides are: An absolutely stupid design of bracket, or rather the way it attaches to the light. It has the usual screw with a knob attached to mount the light on to the bracket - fine. Unfortunately the light doesn't have the usual threaded hole for the the screw, but a separate clip that has the nut thread on, and when tightened holds the whole thing in place. Problem with this design is that the clips will fall out while you are trying to mount the light, so it becomes a four handed job! They need to redesign this or find away of holding the clip in place (hint try a piece of sticky tape or super glue. The PIR is easily tiggered by blowing leaves, while other PIR lights are not triggered, the sensitivity buttons on the remote don't seem to make a difference, but its very difficult to understand what the symbols used on the remote mean, a simple + - would have been better!. The 'manual' is no better in this respect. Would I buy again? Maybe if they fixed the PIR sensitivity issue and the mount.