trueCABLE Universal Easy Fit RG6 & RG6Q Compression F-Connector for Dual Shield (DS) Tri-Shield and Quad Shield (QS) Coaxial Cable, 20 Pieces

I had no issues with these RG6 connectors, unlike other connectors I have used that fell apart during compression. The quality and fit of these connectors are excellent. I always use a signal tester, and so far, I have achieved a 100% signal. I have also used these connectors to replace the one on my cable modem, and each time, I have experienced successful connectivity. Unlike other connectors I've tried, these are not of poor quality. One of the most important features is their waterproofness.

Very easy to put on, even with quad shield cable. Both wire braids fit easily inside the connector. Only, the connectors are not weatherproof, some silicone seal or other method will be required to seal out the weather. when used outside. The solid connection afforded by these connectors should ensure a good ground connection. No weather seal required if used indoors only.

Not too much to say other than they work great. No issue so far. I have only used a few, but feel confident that they will continue to be good.

I was working with an old dual-shielded cable that was cut a bit short. When putting compression connectors on these cables that have the inner shield tube, 1 time out of 5, the two layers of shielding braid and foil would "bunch up", making it impossible to put the connector on the cable before compressing it. This connector did not have the issue. I needed a compression fitting where I could pretty much guarantee that I could get the connector on without recutting the cable, and this did the job. By the way, my preferred installation technique is to spit the compression fitting in two (see picture) and slide the plastic compression piece on the cable before combing the braid back. A double shielded cable might be too thick to put this (or any other) compression fitting on the cable once the braid is combed back. Once crimped, the entire end is shielded and grounded.

Used these for some repair and it fits perfectly I got no issues installing these and I’ve never done coax repair work before

Perfect fit

These, so far, have fit all my RG-6QS cables including TrueCable RG6Q which is hard to do. So far several have split by themselves after a short time. These are made out of cheap metal. The ends just pop off. These need to be made stronger. No other old school crimp connector has failed for me.

I make short cables to attach to my TV’s so if I have to move them or replace them I can easily reach the cable end to disconnect it. Or if I have to replace a cable after the dog uses it for a chew toy. These ends work really well and there’s no loss of signal. Have ordered them before and will order again. They work on double shielded cable and the single shielded cable. Worth the price.