5V USB COB LED Strip Cool White 6000K Dimmable IP65 Waterproof 6.6ft

I use this with my 3D printer to get more light into the print area. The color is a cool white and the brightness is adjustable. The sticky backing on it holds just great against the PETG mounting I printed for it. There is no timer so you will have to turn it on or off manually or get one seperately. If you are using the P1P/P1S don't plug it into the internal USB, there isn't enough power for it there.

I used it on my bike at night it is bright.

Purchased once before and had a good experience with these lights however the second time around wasn't as good. The adhesive on the strips was not protected and came damaged and when I contacted amazon for help they didn't really offer much that worked with my time frame. The seller however came in clutch and helped me and I really appreciate that. Other than the adhesive issue the lights worked great for my project.

So far the lights work very nice, very bright. I didn't get a dimmer switch, as was shown in the description and pictures. I would like to have a dimmer switch or a partial refund.

Lined the inside of my electric bike frame with these green lights, used 3 strips and about 15 feet in total. I also used double sided nano tape I ordered, to easily install these led strips onto the bike frame. Nice and bright!

These COB LEDs are great, I bought these to be more visible at night and even during the day. The lights very cool looking too. Just be careful when it's time to peel the sticky covering off, go slow and gently, you can easily pull it right off the light strip if not paying attention. I had to buy a 2 second strip to even put the lights on my e bike frame. So far it's been a month and still staying in place, even after getting wet. Recommended

Adhesive was on the paper cover instead of the actual strip.

Works and powers great. Very durable outside. Super visible at night. No control is needed but that is its purpose for simplifying DIY projects. The COB silicone is easy to scrub off, just make sure to scrape off the coating on the copper pads if you’re going to solder to it.

Not really orange in colour

It was on fire while I was charging it

So my main gripe with this is that the pictures don't exactly match the product; there is no silicone over top of the entire surface, only the silicone used as the LED COB itself. I went into this knowing that might be a risk (I forgot to look at other review photos, silly me) but it's still disappointing. Bare copper is exposed at regular intervals along the length of the strip, so if this is a concern for you, aim for something IP68 rated. Anyway, some helpful info: For the entire 2m length, power draw at 5.0V is just shy of 2.0A (10W). Most of my USB power supplies drop voltage a bit at this load and end up supplying 4.8V at 1.6A (despite claiming 2.4A capacity; shoddy power supplies I guess, not a dig at the LED strip). If you're using this as a light strip in a Bambu Lab X1/P1 series printer, be aware the built-in USB outlet only provides 1.5A, and so the strip should be cut to a maximum length of 1.5m.