GE - Genteq Evergreen 1 HP 230 Volt Replacement X-13 Furnace Blower Motor

It's a perfect fit for the Lennox AC. The installation was straight forward and easy. It took 5 minutes for the system to adjust to the new motor. After that it runs smoothly and quietly. It's a perfect replacement. It's worth every penny. You'll save about $600 easily by doing it yourself.

Perfect fit into my Carrier air handler and direct plug and play replacement for my dead X-13 style ecm motor. Bolted right up, plug the same wires into the same spots and turned the power back on and my house is cooling back down again. 100% would buy again and I promise to update if it dies on me (hopefully not for a decade).

Good carrier OEM replacement

This worked perfectly in my Trane HVAC requiring the X-13 model. Local company quoted me $1200 for the blower motor to be replaced. I was able to purchase this instead and easily changed it myself. At first I bought a refurbished one, but it started making loud noises after one year. Then I found this new one which is working great. This is the way!

Motor quit less than 1 year old. Squealing real bad, bearings rusted out. What a piece of junk.

Just installed this Evergreen 1hp X13 motor tonight. Replaced an Genteq X13 1hp AC blower motor on an Armstrong system. HVAC contractor wanted $1,100 to replace the OEM motor with this same Evergreeb unit. $1,400 for an OEM replacement. Absolutely insane. I get it, they provide a valuable service, but get real! All in, including some basic troubleshooting, it took me 2 hours to diagnose, research, install, and close up. Worth. Every. Penny. Make sure you check your system specs and the numbers from the motor you are replacing. Measure twice, cut once! Praying it lasts for a good long while!

My factory fan motor gave up the ghost. Looked all over online for a replacement. Found this unit for much less here. Motor was shipped quickly. This is a direct fit for my AC unit.

Product arrived on time, you dont have to be a Pro tech to install it! you only need a few tools to remove the old motor and install the new one, very easy to install...Disconnect and verify no electricity to Furnace before doing any work, you are working with 240V and capacitors that wont joke!(Recommended to wait at least 10 mins AFTER disconnecting power for capacitor to discharge before unplugging the old motor) Defiantly need WD-40 to remove the rust between the fan and old motor for easy removal. So far everything working as intended. I hope that helps and stay safe

Muy buena calidad

Works great to replace a programmed OEM Genteq. Warranty could be an issue though. Amazon does not show a warranty, and when I asked, the Amazon vendor said 1 year. Genteq says 2 years, but how would I be able to claim that?