PAC C2RGM11 11-Bit Interface Radio Integration Adapter for 2007 GM Vehicles with No OnStar System,BLACK

I bought this for my 2007 Saturn Aura Hybrid. Note, my Aura does have OnStar, but I never use it, and never plan to use it. I was a bit worried that the wires and stuff wouldn't match up, but they did just fine.I got this to keep my chimes and my delayed off (when you turn the key off, but the radio stays on until you open the door). The chimes are nice, and they can be heard well enough. They can also be turned off if you wish, but only if you have access to the blue adapter box (e.g. you tear your dashboard apart)I purchased this to use with an aftermarket Sony radio, and everything matched right up. I am very familiar with wiring radios and their wiring schemes, and it still took me a bit of reading and double checking the manual to be sure everything was wired up correctly, but all in all, it wasn't bad. You basically wire this up to your aftermarket radio's wiring harness, and then it clips into your vehicle's OEM/Factory cable clips. If you are a car-install novice, make sure you figure all the wiring stuff in your garage or something before you attempt it in the car... cramped inside a small sedan with wires and tools all over the place sweating on a mid-summer day is not for everyone!Unfortunately, my first adapter was faulty. I wired everything up, double and triple checked it, and my radio would come on, and go off, come on, off, etc... After about 5 minutes, I could see the red light inside the adapter on, and then *poof* (literally, a poof of smoke), it went dead. Luckily, the only thing that went bad was the adapter, and I could wire my radio up using a hot source from the fuse box to get me on my way, otherwise, I would have been without my radio for like 2 weeks. I still could use my radio, but my chimes and delayed-off was non-functional... I called the company that manufactures them, they asked me a few troubleshooting questions, and then had me go through Amazon for a replacement, which was very quick. I then only had to swap the "hot-wire" back to the way it normally would be hooked up, and plug in the blue adapter, and everything worked. I don't think losing a star for a DOA is fair, because faulty parts do happen, and they replaced it without hassle.

2010 Malibu LTthis is what you need to install an aftermarket double din radio. If you bought a kit without that little box, you're gonna have a bad time.

Device works as promised. Integrates perfectly with my Chevy HHR which has the built in subwoofer. My one complaint is that the blinkers noise is barely noticeable, especially when you are driving at highway speeds. The key alert noise is particularly loud when you leave the key in though. Retained power works as it did with factory head unit.

As always these are my go to but PAC seriously needs to update the chime interface sounds.......it sounded the same in 95 as it does in 2022....cheap.

This was a great product to work with and make the head unit install a breeze. As others stated, once it is behind the head unit it is not that loud and hard to hear when the car is running. A bit pricy too

This unit worked well in my vehicle. The only funcion I would change is the chime, it’s not loud enough! Three stars because of that.

Funny enough the trim piece I bought to hold the double din touch screen radio in place came with a wiring harness. Sadly it missed 1 or 2 vital wires to power the radio.It works great. My only gripe is the chime is a lot louder than the factory and is actually annoying.I'm debating between turning the chime off or leaving it on.

Fits great in a 2010 Chevrolet Cobalt. The wires are all self explanatory if you've wired radios before. This harness is designed to make your life easier which it accomplishes very well.The chimes are a little muffled and sound a bit odd at first but you get used to it. The turn signal sounds just perfect now and now the best part is that it does retain the OEM 10 minute continuous power after the key has been removed feature that came with cobalt models. Easy to install, just have someone that knows their cables or at least have a diagram up.

It came early and it works

I wasn't happy to pay $130 for this, but is what I had to do. I wish this harness worled with my steering wheel controls.

Worked as expected very happy with this product

Was exactly what I needed, schematics were easy to read and I saved alot of money getting it on amazon. Hooked up my new double din deck with no issues.

Este tipo de producto es específico, yo que lo usé y es muy bueno!