InstallGear 8 Gauge 25ft Black and 25ft Red Power/Ground Wire True Spec and Soft Touch Cable

This wire actually exceeded my expectations, it is very soft flexible and seemingly durable and carries the current very well. We use it to power the aircraft that we work on via a 13.8 VDC TekPower switching power supply capable of 50 amps. So far we have used this wire to a capacity of about 15 -20 amps maybe a little more at times and it didn't even get warm. We are using the full 25 foot run of both the black and red for this set up (see the attached picture). The voltage drop across the full 25 foot run is surprisingly lower than what I thought it would be under a full load.... at an approx 16 amp draw the actual voltage drop across the wire was less than a volt, (like around .7 - .8 tenths voltage drop). We have only been using this now for about a month so I can't say how durable the wire will be over the long haul but so far it has done very well for the minor abuse we put it thru. The attached picture is current to date and we have used this on many multiple airplanes so far. Over all a very good purchase, I would recommend this to anyone needing a heavy wire to carry heavy current loads. Also we soldered our connectors at both ends to minimize any further voltage drop and the wire worked very well with the solder. Very Happy with this purchase! On another note..... I would most likely not use this wire for any type of welding gear as it is not pure copper wire, just my thoughts. I will update this post if anything about the wire changes, durability etc.

Powers my 410w inverter no problem

Used for chinese diesel heater work very well but keep in mind its not pure copper !

The casing around the wire is too easy to slice into, I dont trust it to withstand a lot of vibration against any sharp sheet metal. otherwise great though

Wire is very fine, but works as it should