Hisencn 16.5" Cast Iron Cooking Grate Replacement for Smoke Hollow PS9900 7000CGS, Charbroil 463722315 463722313 463722416, Kenmore 141.152270 141.155400, Kingsford 24 inch Expert Grill 24 inch

Excellent item. Fit perfectly!

Fits my grill perfectly. Nonstick (at least for now). No problems so far. I've grilled only a few times, but no issues.

I haven't grilled with it yet, so I can only mention looks and fit. The grates appear solidly made and the outer ceramic appears smooth and uniform. Because the corners of my grill are very rounded and the grate corners are close to square, the side edges of the grates have a small gap, but they still fundamentally fit and the grill is still very functional.

I have been looking around near me for some replacement grates for my grill to no avail. After searching with Amazon, I found these. I have an older grill and these fit the model number of my grill. I received these in short order and they fit perfectly. I haven't grilled on them yet but they do seem similar to the ones that came originally with my grill. At any rate, they are better then the ones that needed to be replaced. I would probably have given them 5 stars if I had grilled something on them but have not as of this date.

I searched all over to find a grate that would fit an original Lil Tex Traeger BBQ 070 I was given. This one fit perfectly! The grates are very heavy duty stainless and seem like they should last forever!

Good quality stainless steel cooking grates. The depth was perfect for my old Jennair grill, I only had to shorten the width of one of the grates to fill my needs.

Very nice

Since these are of welded design, you have to work with them a bit differently than the cast iron grates, but for 99% of users, it's fine. I like to get my charcoal bed good and hot, then just before putting the meat in, I lift the grates and toss in some wood chips. With the grill tools I normally use, I can pick the grate up completely, load it and set it back down. With this only having one runner through the middle, I can't balance it to pick it up. I can angle lift it, which also works, but it's questionable if it will slide down into the charcoal bin. The only gripe I have is setting these side by side when they're hot, they expand enough from the heat, you have to really get the alignment right or it won't sit down flat. I probably should grind or sand like a sixteenth inch off of one side to give it just a little play. The surface finish is good, but after my first use, I now have some baked on discoloration... we'll see how it goes the next time, but it definitely isn't rust like the cast iron ones would do. Overall I'm definitely happy.