2 Inch Rear Lift Block Compatible With 1995-2024 Tacoma/Tundra 2WD 4WD, 2'' Rear Leveling Lift Kits with Extra Long Extended Square U-Bolts Raise The Rear of Your Pickup By 2"

I have a 2012 Tacoma, and want to level it after I upgrade my front struts to 2.75 inch difference in front to rear now.I purchased the 2.00 inch lift blocks and proceeded to install them., and the instructions are also helpful. I Jack up the rear and supported it with Jack stands on both sides and left the Jack under the differential on my truck,removed both tires.Next I removed the bottom of the rear shock and then the nuts that held on the u bolts on one side and with a second jack under the axle tube, after the bottom plate was removed I lowered the two jacks and let the springs relax until there was a wide enough gap for the 2.00 inch block to fit between the spring and the axle tube plate. Also it took a bit to get the pin and the hole in this block to line back up on the axle. Once this was done, I raised the axle tube back up and added the new u bolts along with the u bolt plate to the bottom of the axle and put all four washers and nuts back on and tighten. It also helped to remove the 12mm screw that holds the emergency brake cable on to get a bit more slack in the cable when lining it back up with the axle top hole and bottom pin . Make sure you put the smaller end of the tapper in the block facing forward per the instructions. Then I just repeated the same thing on the other side of the truck, and it took around 3 hours to install, also two people are helpful when doing this installation. Now my truck has a nice level stance. I have a few pictures I took after the installation too.2.00 inch blocks u bolts,washers and nuts are all quality components and worked well. I hope this helps you.

Cheap leveling kit, but it works and the quality isnt too bad for the price. I will probably still swap it for some billsteins and an add a leaf but im happy with it for now. Install was a breeze took around 4 hours total and i had no one helping. Minimal mechanical experience but as long as you have a jack, some stands and sockets you should be good.

Great product, did the job. Installed on a 2022 4runner SR5 for reference. Will post before and after pictures.

Considering this is by all means a basic, low budget lift, it does exactly that. That being said, the quality is surprising. The front spacer feels solid and the machining is actually well done. Install is easy if you watch a few videos on it. I've done these before and this one is much better then the one I used on my FJ! I like that the rear spacer is angled to keep the drive line angle where it should be. I installed it and took it right to my alignment guy. It wasn't off by much at all, just needed a small correction.

Truck looks great.

Only 4 stars so far. Minor scratches on one of the spacers. Probably from the hardware in the packaging. They can't be seen from the outer sides of it so won't look bad. Seems to be the correct material as described. Haven't installed yet I just got them in and was on time. After installing a d driving I will update this review. I will upload before and after pics. Lots of reviews about having to grind down the bolts for it to fit. I already knew this just because it's usually always required when installing spacers on any vehicle. I got the 2.5" just to avoid having to do that. Clear instructions and even mentioned the possibility of having to grind them down so not sure what everyone's issues was with that and not getting good instructions on how to do this. I'll say this, if you need clear instructions on how to install something like this then you should probably just have a shop do it for your lack of commen sense on working with suspension components on vehicles. This should clear up my tire rubbing issue from installing 33" tires. I already have wheel spacers on my rig so this will help make it look better too.2007 toyota 4runner limited v8 without xreas suspension.

Buena calidad

Muy buen producto

La calidad del material del producto más que perfecta, está instalado en mi vehículo y hasta la fecha sin problema, además de la terminación de las piezas muy estéticas en comparación con otras “hechizas “

No batalle nada...

Queda muy bien y da un espacio de altura muy bien