Twidec/2M NPT 1/2" inch (6X100MM) Pipe Thread Temperature Sensor Probe Two Wire Temperature Controller (0~600℃) 304 Stainless Steel K Type Thermocouple MT-205-1/2

Used this one on a powder coating oven and it works great. It is very accurate and I didn't have to adjust my PID controller at all after checking its accuracy. The only thing that I would change if I could would be the length of the cable; I would like for it to be a little longer, other than that I am very pleased with this purchase.

So far so good I used this for eight months last year to tell me the water temperature of my coal boiler no issues

Good quality

I decided to add a smart temperature alarm to my beer brew pot. I experimented with some cheap meat thermometers but they got corrupted by the liquid beer wort and gave faulty measurements. This real "k-type" thermocouple screws into the threaded boss where the mechanical thermometer was installed and without any calibration trim measures 211.8'F with boiling water, so close enough.

Accurate and does what it is designed to do

Works great

I bought this as part of upgrading my electric smoker. So far so good. It plays nice with my pid and seems to report accurate temp.

Not a bad thermocouple for the price. The NPT threads aren't too bad and don't leak even under pressure. A good value for the money for sure. Wire appears to be fiberglass insulated which is a plus if you're working with higher or lower temps.

Works well, very accurate good quality.

Bon produit mais la livraisoBon produit mais la livraison par AMAZON PRIME a pris 7 jours au lieu de 2-3 jours.

good quality and is working well. note, if your using a esp32 / arduino, you'll need a board.

Long cable and good quality throughout. Accurate temperature readings. I would buy again.

Fast delivery , very nice quality , runs my brewing temps bang on , I’ll be buying more , thanks