Hitachi MAF0031 Mass Air Flow Sensor , Black, 1.46 x 1.82 x 3.57 inches

100% OEM, turned off engine light as soon as i plug it in, really cheap and fast shipping, worked with my nissan murano 2005, should work for most cars of the same v6 engine. Just make sure you disconnect the battery for 10-15 minutes and once the time is up you honk the horn or turn on the lights to make sure the whole system is drained of power. Then replace the sensor using a T20 tamper proof bit, make sure the sensor faces the same way as the old one, the little glass wires should face away from the throttle body, and towards the intake filter. Hand tighten the screws, then plug in the battery and start the car up. Worked perfectly for me.

My engine check light went off because of this great mass air flow sensor. It's the best price I found online or at the local auto parts store. It works with my car. The quality is excellent since it's the original factory part that came out of my car.

I was experiencing a dangerous issue with my 2005 Nissan Murano: the engine would randomly shut off while driving, especially when coming to a stop or slowing down. After some troubleshooting and attempts to clean the original MAF sensor, I decided to replace it with this Hitachi sensor, and the issue was resolved immediately. Since installing this MAF sensor for myself, the engine runs smoothly, the idle is stable, and it hasn’t shut off once. This part is clearly OEM-grade, fits perfectly, and no additional setup is required. It restored full reliability to the vehicle. If you’re dealing with engine stalling or shutdowns, this sensor is highly recommended. Don’t waste time trying to fix a failing sensor—replace it with Hitachi and drive with peace of mind.

I bought this MAF sensor for my 2012 Nissan altima, started malfunctioning with low RPMs not going over 2500 I got it scanned at autozone and the diagnosis was the one I attached on the picture, code P0101 and a few more,I replaced the MAF sensor with this Hitachi one and it cleared all the codes and it's working good after 3 weeks,you need to disconnect the battery before installing the sensor to reset the computer,reconnect the battery after 10-15 minutes, God bless you🙏🏼

Part didn't fit 2013 Nissan Altima AND the product arrived opened with seal broken. Not new.

Installed and everything working great. One thing i noticed is box and sensor says Astemo instead of Hitachi. Papers inside says the new company is now called Astemo Hitachi now. Well see if I encounter any issues later, but so far everything is working fine.

Fit 13 Nissan Murano, this with the air intake boot fixed my p0101, and fixed limp mode and all drivability and idle issues.

Installation was easy, worked for my Nissan Rogue. Car had gotten a code having to do with my intake temperature sensor which is part of the MAF sensor in my car, some cars have them separated. My car eventually wouldn’t start, once I swapped the sensor it fired right up, code didn’t clear but I cleared it with a diagnostic tool and hasn’t returned since. Hooray! This part was 140$ had I bought it at a shop/auto store, no thanks

Was recently having some issues with the car randomly stalling and idling problems. Been chasing this problem for about 5 months now. Damage to the old MAF was caused by a mechanic that did some valve cover work, which was very horribly done. Code that was always flipped was the P0300, which can be basically anything, so its hard to chase electrical issues. But this may finally have solved it! Played around with the old MAF, and there were signs that it was the problem. This sensor worked right away, plug and play basically. This is a new brand name of Hitachi, called Astemo now. Made in Japan, and it is the OEM manufacturer for the car. So far no issues, great product, and I hope for it to work long term. Overall 5/5! Luckily I did not get a used/old product as some others have said. This was brand new in package. Car is a 2012 Nissan Versa 1.6L. I added a picture of the compatible cars that is in the package.

Plusieurs modèle chinois essayer avant aucun ne fonctionnait, un peu plus cher mais pour l’instant fonctionne très bien, mon Murano 2012 ne cale plus en partant et le code n’est pas réapparu. Moins cher que la pièce d’origine (+500$)

Product does not work. Engine Light back

Works well (so far), SES code didn't return after few weeks, keep fingers crossed. Delivery on time

I bought it the last January 13 2021, and today October 17, 2022 the sensor doesn't work anymore, so almost two years it worked. The Original worked for 6 years, so I need to buy I new one and I thinking to buy the original part.