4 + 1 Bay DIY NAS Enclosure, 4 x 2.5/3.5 Inch Tray + 1 x 2.5 Inch Internal Bay, MB ITX PSU Flex, Front USB 3.0, 8 cm Chassis Fan, Hot Swap Backplane, Network Attached Storage

It would be even better if it was 10% larger with better wire management. I wouldn't go higher than 6TB HDD, as there's not much airflow. I'd like 8, 10, 12, 16 disk versions as well please. A version with a standard ATX power would be nice too :-)

top gelaufen

別にNAS用のケースを欲しかったのではなくMINI-ITX用のPCケースでHDDが4本収納できるコンパクトなケースを探していたところ本商品をたまたま出くわした。値段が少々高いとは思ったものの即決で注文。到着は予定日よりも2日遅くて多少やきもきした。 大きさは他社のMINI-ITX用PCケースより一回り小さく狙い通りだった。ただしその分マザーボードやCPUファン、電源の搭載や配線ケーブルの取り回しには一苦労した。何度も改造をしたい方には不向き。

The case is small and the video build is misleading. I used a 1155 itx MB and i5-3470 cpu with a Thermalight AX90 cpu cooler (35mm). However, the MB cannot be installed without removing the HDD tray. To remove the HDD tray the front cover needs to be removed (4 screws and 4 tabs). Then remove 4 screws from the back and 4 screws from front and the HDD tray can be slid out the front exposing the MB mounts. There is about 1mm gap from top of cpu cooler and bottom of HDD tray when reinstalled. If noise is an issue, replace the 80mm fan with quieter fan. As mentioned in other reviews, there is little airflow, but temps seem ok at stock settings. Other than a challenging build, the case is great. Have fun with it.

Lots of modding to get everything to fit but in the end it's a very quiet raid10 NAS using an old micro Alienware I had lying around (All fans replaced with Noctuas). There is only 1 cpu fan that actually fits in this case and since I didn't buy that one I decided to bend the frame of the case to get the motherboard in and lucky enough it had no issues closing the case when bent back. There is also no airflow into the case so I had to drill a hole for a 40x10 noctua as well as another hole for the light up Alienware head on the front (see pics).