5 inch Super Thin Diamond Blade

Great quality and cuts thru granite like butter! I am a DIYer and they work great. No effort to cut (watch my video). Used on my DeWalt angle grinder.

I recently used the EZARC 4-1/2" Super Thin Diamond Cutting Wheel for a metalworking project, and it exceeded my expectations. The wheel delivers over 5,000 cuts, significantly outlasting traditional bonded cut-off wheels. Its ultra-thin design ensures precise, clean cuts with minimal burrs, making it ideal for various metals, including rebar, steel, and iron. The solid steel core reduces the risk of shattering, enhancing safety during use. Compatible with most 4-1/2" angle grinders, this wheel operates smoothly. Overall, it's a durable and efficient tool that offers excellent value for money.

I have used these to cut thro quartz, tile, porcelain. Cuts like butter.

It was just what i needed for my project.

I truly can't believe how good these blades actually are! I was remodeling a bathroom and upon removing the old sheet vinyl and luan, there was major water damage on the original 3/4 inch oak tongue and groove subfloor. I started with my multitool using a carbide blade and that worked well until I started hitting the "cut nails" (hardened steel, usually reserved for nailing wood to concrete). After several minutes of frustration and a few burned out carbide multitool blades, I decided to try these... All I can say is they worked SO VERY WELL that it only took a few seconds per nail, also cut through the 3/4 oak, and STILL have plenty of life left in the blade! I know these are not their intended purpose, but as a contractor for several decades, you sometimes have to "think outside the box" and these blades were the perfect solution! Highly recommend!!!

These blades cut well for the money. I'm using them on porcelain pavers. Cuts right through them and I'm able to east the edge of the paver with them after the cut.

I bought this to complete my diy tiling. Do not waste money at home depot. This is cheap and it last forever. The only time I had to switch out blade is because I dropped it and the blade became crooked.

This disk has the shaft diameter PRINTED on it as 9.5mm, which is 0.3740146". This is close, but will NOT fit a 10mm shaft. I was looking forward to using these, but not a chance.