1ft 16x16mm Led Channel Diffuser Black Aluminum With Mliky White Cover V Shape

Corners are hard to snap on. There is just a tiny ledge that the rails fit into. Would be great if corners were made to fit better. Otherwise no issues

I set these up behind my bar to highlight bottles. Was looking for a nice wedge diffuser and this was an easy to use set.

Do yourself and purchase a longer screws of the same type and size, especially if you're going into particle board. If you drill a tad too deep they'll strip the hole immediately.

There are so many things about these that I wanted to like. I should have done more research to be honest. I bought 9 packs of these to do my bedroom. First of all they are not actually a full foot per unit. They are short by just a fraction which threw off the entire mesasurement by 1 unit by the time I was done meaning I had to buy yet another full pack to get just ONE more unit. Secondly, the diffuser shade is damn near IMPOSSIBLE to get into place because the chanel is so shallow it keeps popping out and is infuriating to get into place. which means I had to take the ENTIRE thing down once up to wrestle these things into place just to put them back up to its turning into a multiple day operation which should have just been a couple hours. These two things compared with the cost per unit is just too high. I do not reccomend these at all, and will be looking for another option when I go to do my living room (if I ever get the bedroom done that is) Hard pass, would not buy again. Find another option that is just not this. save your money.

Dont try cutting em. I went for the 45 degree corner manouver. But you need to get the clasps 100% perfect or the whole thong looks terrible (thin edges that dont butt up they just overlap and look cheap.) Probably get a better result with tape. But as they are without cutting..pretty perfect. End caps were a nice touch. Diffuser can be a nightmare as it just wants to eacape until its balanced in its shallow little (very very little) slot..

I used these under my cabinets with led strips to protect them from water or grease. They are impossible to install under the cabinets. It could be how low my cabinets are but I would have to lay on the counters or bend over backwards to try to screw in the brackets. I ended up using double sided foam tape that came with the LED strips to attach them. I wish these channels came with the tape as another option to install them. The plastic cover is also very difficult to slide into the channel. I had to bend them to get them to snap in. The little end caps are useless, the wire of the legs wouldn't fit through them but I don't think they are needed. They look good once installed though.

Bought it to dim out led strips .works perfectly

dont really defuse leds very well.

Whoever‘s job it was to cut these need to find a new job. They look like crap.

If you are looking for something that diffuses the light well and is easy to install then this is not for you.

El perfil se desempeña bien, aunque desde mi punto de vista debería de venderse también uniones en 45° para poder manipularlas.

El difusor hace que la luz de los LEDs en una tira se vea más uniforme, y le da una apariencia más elegante a la instalación. Hay que medir y perforar para instalarlos, pero no es tan complicado. El difusor puede ser ligeramente difícil de insertar en la guía, pero nada que no se pueda hacer con algo de paciencia; y en teoría lo haces sólo una vez y te olvidas.