DAYBETTER Waterproof Led Lights for Bedroom, 32.8ft (2 Rolls of 16.4ft) Led Strip Lights, 300 LEDs Color Changing RGB 44 Keys Remote Controller, 12v for Outdoor Room Home Party Christmas Decoration

I was looking for a permanent solution to Christmas lights, and I think I found it. These lights are water resistant. Even though I am in Arizona, we see little rain, these should hold up well. The 3m sticky back is great for holding the lights in place, but I would recommend a coax staple of some type to reinforce them. Again living in Arizona, I can see this adhesive wearing out and getting soft in the summer. I mounted to strip to see how I wanted them for Christmas lights, one strip behind the facia board and one in front. I will be mounting them in front under the lip of the roof. I would like to add more behind the facia board though because they allow for a more subtle illumination that would be great for other times of the year. I left these on for quite a while and the temp of the power supply was warm, so I would consider putting a timer switch if some type, or remember to unplug or turn off during the day. I wouldn’t leave them on constantly unless I had a better power supply. I would say the one downside would be the power supply, because of this you can only have 2-16ft strands running off of one power supply. I would not try to connect more than the two strips to one PS. If you are using these for Christmas or other, where you will be using lots of strands, you may have to run extension cords and such to make it to all power supples. Their is a picture on here already of the type of staple you can use to secure the light strips and power cords to the back of the facia. All in all I am pretty satisfied with this product and will be buying more in the future to spruce up my backyard lighting, and add some other lighting effects around the house. :::UPDATE: The lights are looking great, and the temperature of the power supply is not an issue. If I am going to leave them on extended periods of time I just turn the brightness down. Checked on my power supplies and they were cool to the touch. I would also say, lay out and plan ahead on where you need to hook up power and how the corner bends will work, to make sure the polarity lines up if you are using L connectors. I have probably a 6-8ft strip that I had to cut off and take down and redo. The good news is though, I can always use the extra strip somewhere less as long as I have a solderless connector. So really there is minimal wasted product. I just have a lot leftover, but I will use it up

Great lights for sons bedroom. Power adapter cord is very short so look at getting extension adapter. Lights are great and easy to install. You can either connect two goin in opposite directions or connect two in series with separate connector you must buy separately for 10mm lights. Plus attaching connectors takes a bit of work to remove waterproof rubber to expose copper to allow connection.

I put these light strips in our basement storage room. I wanted to make a fun place for the kids, so I installed an outlet with switch and put the lights on the ceiling for them to play with. I wanted to get a remote that wasn't frequency based, since I already had another led strip like that and didn't want it to Hijack control of. The kids love the room we put together for them, because of the fun lights and clouds. Note: The sticky back will pull off a layer of drywall or paint when removed. When I had to remove and adjust, I definitely saw the chunks it was pulling off. All that being said weven had them up for over a month and there have been no pieces that have come down. I also just used the sticky back no other fasteners to keep these on.

These are great lights and I love the different color choices. Except the white, which is really blue. Hence the four stars. I needed to use the white option and it is so cold and blue that I had to replace the lights. But most people will probably want these for the other colors so they work well for that. The remote is okay, but it's pretty cheap and it's kind of hard to figure out where to aim it to get it to work right. Also, the adhesive isn't very strong so if you need these to really stay stuck, you'll want to use something else to hold them down. But they're still cool looking and put out a nice amount of light. Overall, they are really fun lights and I love LED strips. These are the waterproof ones so they are thicker and not as easy to bend sideways, so be aware of that. If you only need them for inside, get the non-waterproof ones that are thinner.

This was my first attempt at lighting anything other than a film set....and I have to say that these lights look FANTASTIC! Installation can be as easy or difficult as you'd like it to be. The kit came with (barely) enough screws/hooks to hold both strands of lights up on my bedroom ceiling. A few extra screws/hooks would've been greatly appreciated to account for corners/beams etc. The lights are REALLY bright and can be dimmed substantially. I wish the lights could go even dimmer, but it's probably a limitation of the technology. The colors are beautiful and the remote makes customization a breeze! You do have to have a relatively clean line of sight to the remote's receiver...which is where the strands plug into the power cord. Ideally, the strands would be one long strand instead of two shorter strands (albeit, such a product doesn't exist on Amazon). I wish the power cord's color matched the white/off-white strips and hooks :/ That was a stupid design choice that would've made a MASSIVE difference for the vast majority of people using these lights on their ceilings. The double-sided tape was frustrating to get started, but appears to be holding up pretty well! Overall, great lights at a great price-point! They look beautiful and I have no regrets in my purchase! :)

Love the way they look but after a few months, some of the lights won’t turn the correct colors. One strip stopped working completely.

La adhesión es regular