rain bar Unit

This worked great for me as a modification to my Rena Filstar xP4. The Filstar didn't have a spray bar so this worked and fit perfectly! In the photo it's the right hand side spray bar and what you see is three of the four pieces it came with. This is a 90 gallon tank for reference. I debated a DIY with PVC, but decided against it and went with this instead. I'm very happy with this product and for the price you can't go wrong.

I have a 225g axolotl tank with a chiller. The output was too strong for the girls so I needed an easy way to keep the flow but distribute the output. This worked perfectly. Attached right to the output hose and included suction mounts to keep it in place. Arrived within 16 hours of ordering! The cost was much less than anything else like it too!

If I could this 3.75 I WOUD over a full 4. First off let me start by saying I purchased this for a Fluval 306 to replace the "duck bill" nozzle it comes stock with and place it across my 50 gallon tank. I bought the 23-30" set as my tank is 36 inches long and used the all the sections for the full 30". Now take note of the thickness of each size kit. either 12/16mm or 16/22mm. The larger mm is for the elbow connector. The 16mm elbow was NOT thick enough to fit the Fluval 306/406 series rubber connectors. I did however get it to fit snug after applying a bit of electrical tape. The larger 22mm elbows for the longer sparybar kits may fit the 306/406 tight without tape as another reviewer noted. However this size only comes with the larger kits. If you dont need that long of a kit you can just not attach one or two of the bar sections but you are going to pay for the longer size when you dont need it. The other minor issue I came across was the bar sections not being super tight when connected together. Now, they arnt rotating freely or anything like that but they were not water tight. When I first hooked everything up and flipped on my filter you could see slow drips of water at each connector point of the bar sections. Is it a huge deal? No not really. But it means you are losing water pressure at those points. I ended up putting small pieces of electrical tape inside the fittings before pressing them together and that made the seal super tight!. No more loss in pressure. The only other minor gripe was I had to take a drill bit and even out the holes on the spray bar. It was like they each had a different diameter so the water would spray out of each one at a different angle and pressure making it hard to get the stream of water uniform. So all in all its a good spray bar to replace the funky duckbill of the 306/406 series filter and with some small minor adjustments, I got it to work quite well. Maybe just a little more quality control in manufacturing these is needed and id give it 5 stars out of the box.

I paid nothing for this, and it’s one of the best attachments I have bough for the money, great for nano tanks

This is a cheap piece of garbage!

The sections of tubing are warped like in the picture. I had to heat up the tube and bend it to get it somewhat straight. The suction cups don't work well. One is too big (clip is bent out too much) and both of them fall off easily. One broke already with light pressure. I'm ordering separate suction cups and can update the review once I have it fully installed. I like the size, but would pay more to have it more functional.I read that people had to make larger holes. This isn't a big deal if you treat this like a DIY project. I'll see how the flow is in my 20 long and update.

The description said it came with a 5/8" adapter, which it did not. Even it if had, the spray bar pipe was extremely narrow to take on a 5/8" pipe flow.Amazon discontinued carrying Flow Tamer brand for this brand, which is of much lower quality.

Very Good product. However, despite what others have said, it does not fit fluval canister filters.