Linkstyle 4PCS 12V Interior LED Light Bar, Super Bright 12V LED Light Strip with Switch, 108 LEDs 1800LM Enclosed Trailer Lamp Lighting for Car RV Camper Boat Energy Efficient

I live in an RV, so I added these lights to all my fixtures to increase the light.Man, what a difference.!!

If you are looking for this type of lighting go no further. They are inexpensive, install easily, are of decent quality (for what they are), and should last quite awhile. Unlike others that have three wires and a confusing hookup, these are actually the same light, but pre-wired internally where only a red and black wire exit the unit. If you can't figure out what to do with those then you probably shouldn't be shopping DIY products. Additionally, there is a small rocker switch near the end of each light that allows individual control if desired when they are all hooked together. I found the color temperature to be excellent for my application, (inside of an enclosed trailer), which allowed for penetrating light around all the items without being harsh. Four lights in a 17 x 7 foot space was almost too much, these are bright. But it will be excellent for working on projects at the bench without straining my eyesight as I did in the past with the basic bulbs installed in the trailer. (which I turned off, they had a larger power draw and were dimmer than these new LED units).And for the several that I shopped, these were the only ones I found that had a listed warranty. At about $6. a piece, for the light output they give, they are a bargain.I paid for these myself and have no affiliation with the company that sells them.

If you need some lights for a shed without 120 volt power, these will help with lighting up the dark interior of a shed to see what your looking for. Each light has a little on/off rocker switch on the side and comes with 2 mounting clips with flat head screws for the light to snap into. The 2 conductor Red/Black wire pair is very small gauge ( Fine Wire ) so I recommend soldering to a larger 2 wire conductor, such as Bell wire and use heat shrink tubing to insulate the connections. Of course, not as bright as the 120 volt , 4 foot LED Tube Strip lights that are sold on Amazon, but these will light up small spaces with no problem.

Lights work well, but wires are so thin they are hard to work with without tearing or breaking them during stripping operation.

I bought these for the interior of my Jeep JK. I really wasn't sure how they were going to fit other than I knew it had a double sided adhesive strip and/or metal clips for mounting. Since I received a pack of 4, I tested all to make sure they worked and they did. I've used one in my jeep, using the double sided tape to stick it to my hard top. It stuck great until the summer sun beat down and then gravity took over. I re-attached it several times and found it on the floor a short time later, so I decided to use the included clips. I pre-drilled 2 small holes and used the provided screws and clips & it now stays firmly in place. I love the fact you can wire these in directly and then use the on/off switch - very bright! I can't give a rating on water resistance because they are used within my vehicle.

Lit up my van like a box store

Four of these lights down the center roofline of a forty foot sea container provides plenty of light. I wired these in parallel to a standard car battery with a 100 watt solar panel and controller. leaving the switches in the on position, I can turn on the whole string with a button on the controller at the entrance. I had to use magnets to mount the lights and magnets with hooks for the cable because in the summer the metal gets too hot for any kind of adhesive to hold the lights up, even though they barely weigh anything. I am very happy with this purchase.

3 out of 4 work, I guess that's 75 percent.I could not get one of them to work. Haven't figured out why. Just strange 🤔