48 in. Peel and Stick Above Ground Pool Cove - 22 Pack,White

I read alot of reviews before ordering, many good and even more bad saying they didn't stick but I decided to order anyway.I was very happy, they all stuck well on our 24' above ground and were easy to work with, I also saw some pics and videos where they duck taped the seams between and did that also. I expect them to hold up well for years to come.

Why did you pick this product vs others?:I needed to replace the liner in my above ground pool after 20 years of service. As I did back then I installed cove base around the pool wall circumference over a bottom liner pad. Cove base is relatively inexpensive, easy to apply and cheap insurance for your pool liner. It serves as a gentle transition between vertical & horizontal eliminating most of the stress to the liner in that area. A good bottom pad shields the liner from any sharp stones or other items that may be present in the base material. These two items (I feel) were the main reasons I got so many years out of my pool liner.

These worked great to install our new pool over the summer. Much better than having to built up the sand on the sides before putting the liner in.

Product is excellent in Adhesion, ease of install, and value. One note why I didn't give it 5 Stars. The number of pieces comes up about 1/2 to 3/4 short of fully going around a 15 x 30 pool. You will need (20) total pieces, not the (19) that comes with the package.

Good product. I had a little extra for my 24' pool. Super sticky, stuck them to the pool wall and they never came loose.

What a product! With someone else helping, these were installed in my 24' above ground in less than 5 minutes - that's not an exaggeration. I have done a few pool liners over the years. I'll never do another without this product. Far superior to a sand cove, and super consistent. It made for a great finish for my latest install. What I liked best was knowing for sure my sand floor is flat, because I could see it meet the wall instead of burying that intersection with sand and hoping it was right.Pro tip: Peel the adhesive backer about 6", and fold the backer piece straight up, press the cove into the corner, keeping the cove tight to the floor and the pool wall with one hand, pull up on the backer with the other. Do this about every 12 inches as you go, and you will install every piece perfectly and quickly. The backer is super sticky, you don't want to have to reposition if you don't have to.If you have a 24' round pool, buy the 24' round kit. I read several reviews about this coming up short and was worried. I have a 24' round pool and I ended up with an extra 1.5 feet. I imagine oval pools could be an issue though, so pay attention to reviews specific to the pool size and type you have.

These were easy to place. We had to readjust due to a storm blowing over while the pool was filling. We were able to get everything back where it needed to be.

Did not stick, put some water in the pool and half of them came off the sides